Doubling the life of NAND flash, Altera has developed a storage reference design, based on its Arria 10 SoCs, that can also increase the number of program-erase cycles by up to 7x compared to current NAND flash implementations.
Freescale’s QorIQ LS series processors, built on ARM architecture, deliver unprecedented efficiency and scale for the smarter, more capable networks and industrial infrastructure of tomorrow, says the company. The QorIQ LS1 family is the first in a series of ARM-based processors that bring networking know-how and robust connectivity to applications as wide ranged as programmable logic controllers, IoT gateways, and consumer broadband home routing.
Silicon Labs Si114X proximity / ambient light sensor modules are low-power, reflectance-based, infrared proximity, UV Index and ambient light modules with integrated single IR LED, two additional LED driver outputs, I2C digital interface and programmable-event interrupt output.
The Lemo 0T series of cable-mount circular connectors is designed for outdoor and harsh applications. The chrome plated brass bodied connectors include an inner sleeve and seals to prevent penetration of solids or liquid contaminates and are G keyed.
Panasonic’s HES relay is designed to meet the combined requirements of different markets (solar inverters, charging stations, elevator systems, motor control, white goods, etc.) in one switching solution.
Offering superior sensitivity stability over temperature and integrated protection features, Texas Instruments has introduced the DRV5013-Q1, a chopper-stabilized Hall-effect magnetic sensor.
Avago’s 5MBd digital optocouplers are primarily designed around lower power consumption and lower supply voltage applications. The ACPL-x2xL devices draw less than 10mW without compromising signal isolation capability or integrity.
The STEVAL-ISA162V1 Evaluation Board from STMicroelectronics. The new evaluation board implements an isolated flyback (12V/0.84A) 10W wide-range mains developed for general-purpose applications. The core of the application is the VIPer25HD, an off-line, high-voltage converter from the ST’s VIPerPlus family.
Murata’s MGJ3 and MGJ6 series of configurable output voltage high-isolation surface-mount DC-DC converters are optimised for use as high-side and low-side gate drivers in IGBT and MOSFET bridge circuit designs.
Texas Instruments (TI) has introduced the LSF family of bi-directional voltage level translators which are operational from 0.95 to 4.5V (Vref_A) and 1.8 to 5.5V (Vref_B). This allows bi-directional voltage translations between 1V and 5V without the need for a direction pin in open-drain or push-pull applications.
Cornell-Dubilier CS Series multi-pin metallized polymer capacitor network is ideal for the low ESR/ESL requirements in DC-DC converters and switching power supply applications, says the company.
Offering high performance and reliability, Yageo’s high CV multilayer ceramic chip capacitors (MLCCs) feature high capacitance and mid voltage characteristics and are available in X7R, covering 1μF to 10μF in capacitance with 0805 to 2220 in case size and voltages from 50V to 100 V.
The Fairchild Semiconductor FIS1100 Evaluation Kit – a 6D MEMS inertial measurement unit (IMU) with sensor fusion to specify system level orientation accuracy. When using with the supplied XKF3 9D sensor fusion, the system features an accurate ±3 degree pitch and roll orientation and a ±5 degree yaw / heading typical specification.
Around one third smaller than its predecessors, the new from Murata Power Solutions MTC1 series of miniature isolated 1W regulated single-output DC-DC converters is available with nominal input voltages of 12 or 24 VDC and accommodate a 2:1 input range around the selected nominal.
The Texas Instruments (TI) LMH1218 – a low-power ultra HD cable driver is a low-power cable driver with integrated reclocker. The relocker is used to drive serial video data compatible to SMPTE-SDI, SMPTE 2022-5/6, 10GbE Ethernet, and DVB-ASI standards.
Littelfuse has expanded its popular LV UltraMOV varistor series to provide solutions for applications with higher DC voltage and surge requirements. The series, introduced to the market in 2013, originally offered continuous voltage ratings from 14VDC to 56VDC with surge current rating of up to 8kA (8/20μs pulse).
Optimized for USB and other hot-swap applications, the AP21410/AP21510 single-channel current limited power switches introduced by Diodes Incorporated target manufacturers of laptop computers, tablets and Chromebooks, especially those deploying the new Type-C USB port.
A versatile high-frequency switching regulator with an integrated high-side high-voltage power MOSFET, the Monolithic Power Systems MP4559 step-down converter targets applications such as high-voltage power conversion, automotive systems, industrial, distributed and battery-power systems.
